Preparation of an end or input test mass (ETM/ITM) (Hydroxide-Catalysis Bonding of ears)

Document #:

LIGO-E1000278-v4

Document type:

E - Engineering documents

Abstract:

This document goes through the procedure for preparing an ETM/ITM test mass (D080658-v3 and D080657-v3) for monolithic installation into the quadruple suspension structure. The procedure consists of hydroxide catalysis bonding on a fused silica ‘ear’ (suspension element according to D080751-v1) to each of the surfaces S3 and S4 in a well-defined location and re-storing the mass. General hydroxide-catalysis bonding procedures are detailed in E050228. The procedure assumes the mirror substrate has been fully prepared with HR and AR coatings applied to respectively the front and the back surface of the substrate. It includes mirror handling with the ergo-arm during these procedures. Mirror handling procedures with the ergo-arm are detailed in T1000082.

Files in Document:

• E1000278-v4 - Preparation of an end or input test mass...pdf (128.0 kB)

Other Files:

• E1000278 - Preparation of an end or input test mass (E...doc (714.0 kB)

Topics:

• Suspensions
• Final Design

Authors:

• Margot Hennig
• Marielle van Veggel
• Russell Jones
• Karen Haughian
• Liam Cunningham
• Nicola Beveridge

Keywords:

aLIGO suspensions quadrupole suspension monolithic suspension ETM/ITM hydroxide catalysis bonding

Notes and Changes:

04/08/10: Requested DCC number for the document.
08/04/10: Release v1 onto DCC.
18/02/2011: Release v2 onto DCC.
31/03/11: Release v3 onto DCC – added a small overview schedule at the start of the document
02/08/11: Release v4 onto DCC – added procedural steps to measure the width of the mass at the bonding jig location, added procedural steps to check the position of the ears and prisms on the mass, a flag to slant the mass slightly to prevent the ear from drifting away from the jig

Related Documents:

• LIGO-D080657: aLIGO, COC Input Test Mass (ITM) Substrate (D080657 ALIGO COC ITM SUBSTRATE)
• LIGO-D080658: aLIGO, COC End Test Mass (ETM) Substrate (D080658_ALIGO COC_ETM_SUBSTRATE)
• LIGO-E1000277: Preparation of an end or input penultimate mass (ETM-PM/ITM-PM) (Hydroxide-Catalysis Bonding of ears and gluing prisms and magnet flags)