LIGO Document T2600448-v1
- Waveguide-based Optical Parametric Amplification (WOPA) is a promising alternative that could simplify the conventional cavity-based squeezed-light sources used in the LIGO detectors: a single pass of 532 nm pump light through a periodically poled lithium niobate (PPLN) waveguide produces squeezed vacuum at 1064 nm without any cavity that has to be locked. How much of this squeezing we actually detect, however, depends strongly on the visibility of the Balanced Homodyne Detection (BHD), i.e. on how well the Local Oscillator (LO) beam is mode matched to the squeezed field. This project aimed to improve the BHD visibility of the WOPA tabletop setup. Because squeezed vacuum carries no classical power, we used a bright 1064 nm beam sent through the waveguide as a stand-in for the squeezed mode, profiled both it and the LO, and designed a new two-lens mode-matching solution placed before the PZT phase-scanning mirror. With this solution the visibility improved from 90% to 91.2%, and the detected squeezing increased from -3.0 dB to -3.20 dB (with ~3.3 dB of anti-squeezing) at ~142 mW of pump power. Using a loss model calibrated to this measurement, we predict that reaching 95-97% visibility would raise the detected squeezing to about -3.6 to -3.9 dB at the same pump power, and to about -4.5 to -4.9 dB at 250 mW. A Gaussian-beam (q-parameter) analysis shows that the lens solution by itself allows a visibility close to 99%, so the remaining gap is dominated by alignment and by the non-ideal, elliptical beam leaving the waveguide. Finally, we work out the expected signal-to-noise ratio of a pump-modulation technique proposed to measure the true spatial mode of the squeezed field, and report on a search for scattered-light sources that will matter for future low-frequency squeezing measurements.
-
- Final Report (WOPA-BHD-Visibility-Final-report_SURF2026-Nishant_v2.pdf, 5.9 MB)
- Other Files:
DCC Version 3.6.0, contact
DCC Help